V2000-c Rfid Access Control User Manual -
: Door Status Sensor (D_SEN) – Connects to magnetic door contact
Before installing the V2000-C RFID access control system, ensure that you have the necessary tools and materials. The installation process involves the following steps:
The Master Code is now restored to factory default ( 999999 or 123456 ), while user data remains intact. 6. Troubleshooting and Indicator Statuses LED and Sound Indicator Key LED Color / Sound Action / Status Access Granted Relay is activated; door is unlocked. Red LED Slow Flash Standby Mode System is armed and working normally. Yellow LED Solid Programming Mode Device is open for configuration changes. 3 Short Beeps Error / Invalid Input
The tamper sensor on the back of the unit is exposed to light or not flush against the wall. V2000-c Rfid Access Control User Manual
Do you need to configure reader options?
To manage system users or security settings, administrators must enter . All setup commands must begin from within this environment. Step 1: Entering Programming Mode
Security isn't just about locks; it's about administration. The manual highlights how to change the default Master Programming Code. : Door Status Sensor (D_SEN) – Connects to
Connect the terminal of the Magnetic Lock directly to the power supply +12V . Wiring an Exit Button
Regular maintenance and upgrades are essential to ensure the V2000-C RFID access control system operates efficiently and securely. The following recommendations are provided:
The back of the V2000-C features a wiring block. Correct wiring prevents short circuits and equipment damage. Wire Color / Label Description Power Positive Connects to 12V DC positive power supply GND Power Negative Connects to power supply ground PUSH Low-level Trigger Connects to exit button or power supply push terminal OPEN Door Button Connects to one side of the exit button NC Normally Closed Connects to the positive side of a Magnetic Lock NO Normally Open Connects to the positive side of an Electric Strike COM Common Terminal 3 Short Beeps Error / Invalid Input The
If you forget your master code, you can reset the master code back to factory default without wiping your existing enrolled users: Power down the V2000-C unit completely. Press and hold down the * key on the keypad. Turn the power back on while continuing to hold the * key. Release the * key after you hear two short beeps.
To enter programming mode, you must use the . The factory default Master Code is 999999 .
