Xprinter Xpn160ii Driver

def set_font_size(self, width=1, height=1): """width, height: 1-8""" w = max(0, min(7, width - 1)) h = max(0, min(7, height - 1)) self._write(b'\x1D\x21' + bytes([(w << 4) | h]))

Connect the XP-N160II to your computer using the provided USB cable. Insert the 80mm thermal paper roll into the paper cabin.

Connect the printer to your network router using an RJ45 Ethernet cable. xprinter xpn160ii driver

Download the "Linux_SDK" or specific Linux drivers listed under "Receipt Printer". 🛠️ Installation Steps (Windows) Connect Hardware: Plug in the power and connect the USB cable to your PC. Run Installer: Launch the downloaded driver file. Select Port: (or LAN if using the network version) and click "Install". Configuration: Once installed, the printer typically appears as in your system settings. Go to "Printers & Scanners," select the printer, and click Print Test Page to confirm it works. IPOS COMPUTER 💻 Advanced Setup & Support WiFi Setup:

This happens when the wrong driver series or baud rate is selected. Ensure you selected XP-80 during the installation setup rather than XP-58 (58mm). If utilizing a serial interface connection, verify that the baud rate in the Device Manager matches the rate printed on the hardware self-test sheet. 3. The Driver Installs, But Nothing Prints Download the "Linux_SDK" or specific Linux drivers listed

: You can find the driver in the Download Section by searching for your specific model.

If the document leaves the print queue but the printer remains completely idle, your might be incorrect. Open Control Panel > Devices and Printers . Right-click your Xprinter XP-N160II, select Printer Properties , and navigate to the Ports tab. Make sure the checkmark is beside the correct USB or Virtual USB port. 2. The Auto-Cutter Isn't Working Select Port: (or LAN if using the network

Choose the driver compatible with your operating system (Windows 11, 10, 8, 7).

Open the extracted folder and double-click the Xprinter Driver Setup.exe file.